A. General ideas
In the project editing mode the area you can work on is a white background with a green rectangle. This rectangle shows the size of the project. Anything that goes over the edge of the rectangle will be cut off when the project is put on the page (the form). When you create a new project, the rectangle will be a certain size depending on the category of the project you chose. Moving the lower right corner can change the size of the rectangle.
The objects of the contour type determine the form of the project, for example, the part that will be seen after the project is printed.
Therefore, keep in mind the following ideas:
1. The size of your project is determined by the size of the green rectangle.
2. The objects of the contour type define the parts of the project that can be seen in the
green rectangle. If your project doesn't have objects of the contour type, then the whole
project can be seen.
3. The project can't be bigger than the page it will be printed on. If you want to make a
bigger project, get a bigger piece of paper and enter its size into Parametersà.